figure.
1
figure.
2 & 3
figure.
2 & 3
figure.
2 & 3
figure.
4
figure.
4
|
1. Using the “looped” end, attach the bow tow-rope to the
bow contact point using a larks head. (see fig. 1)
2. A larks head is made by pushing the end of the loop underneath the bow
contact point and taking the opposite side and threading it threw the loop
pulling it tight.
(see fig. 2 & 3)
3. Take excess and place in hood hatch, pull the rope tight and make the
rope just inside of the hatch seal. Tie an overhand knot in the rope. This
allows you to store the excess rope in the hood hatch without it slipping
back out. (see fig. 4)
***Note, when in compromising situations, it is recommended to store the
bow tow underneath the #1 strap for quick access in time of emergency.***
(see fig. 5)
GO
BACK TO SUPPORT PAGE NOW!
|
