1. Each strap is labeled either 1,2,3 or 4. This denotes the order that they are attached from the bow (front) of the boat to the stern (Back).

**Note, it’s uniform to keep all buckles on the left side of the ski.**

2. The #1 strap is positioned over the hood hatch of the ski. Attach the stainless steel bracket parallel with the hatch, and as close to the seam as possible. Repeat for opposite side.

3. The #2 strap is used to keep the sunglass storage and the sides of the front seat from opening up.
Align this strap by placing the buckle so the tip of it is just short of the ending of the seat, place strap so it covers the sunglass storage and continues over the other side of the seat. Remove rivets and mark holes where drilling is needed. Drill holes and attach rivets. Repeat for opposite side.

**Note, there is a loop on one side of the strap, this is for an optional use of attaching Velcro, rope, carabineer or some other type of attachment to hold rope securely in gunnel while in transport**

4. The #3 and #4 straps are attached by removing the black seat holster/handle and placing the screws through the hole in the straps provided.

The #3 strap is positioned under the closest to the bow of the PWC. The #4 strap is positioned closest to the stern of the PWC.

5. Reattach the seat holster/handle to the hull of the PWC. Return seats and pull straps tight. Ready to Go!

Finished look and Ready to Go!

GO BACK TO SUPPORT PAGE NOW!